A Niess Enterprises Company

Mark V Specs

A. Variable speed lubes and sizes to 5500 per hour

B. Uses Ballisti-Cast dies and Star

C. Lube tube preheater (faster warm up time on very hard lubes)

D. Auto digital heat controller on base plate (+ or – 1 degree)

E. Harden tool steel used in stress points

F. Auto shutoff (when lube cylinder runs out of lube)

G. Quick lube refill (no more cap removal)

H. Weighs 150 pounds

I. Air consumption 2.9 C.F.M at 100 psi

J. 120 volt power

K. Dircet drive ( no belts for less vibration)

ABC-14 machines provide vari-speed rate control and feed pistol bullets base up or down at rates above 6000 BPH. Customers routinely comment on feeding 5000 bullets without a mistake. ABC-14 will collate 9 MM through 45 L.C. bullets and requires less than 5 minutes to change over caliber size and shape. Does not collate full wadcutters.

The standard collating plate will feed 9 MM .550" long bullets through 45 cal. .950" long bullets. Special collating plates are available for bullets 1.312" long to .400" long 22 cal. (rifle bullets).

Round nose, semi-round nose or pointed bullets feed with great accuracy, mistake rate (reversed bullets) average less than 1 in 7000. 9 MM and .38 SWC miss rate averages 1 in 5000. 44 mag. 240 gr. SWC and .45 cal. 260 gr. SWC have higher miss rates averaging less than 1 in 1000.

The collator plate drive motor is variable speed, operating from 3 to 7 RPM and is set with a rate control knob. The electric stop-start feed control prevents feed tube overfill. The feed tube is adjustable for bullet size.

The ABC-14 adapts easily to any machine accepting tubed bullets and feeds pistol bullets base up or down, change-over requires 5 minutes. Feed tube O.D. is ⅝".

ABC-14 is furnished complete, includes feed tube, flex bends, electric control, mounting column and plastic piping.